 |
|
|
Three Contacts (Tees):
The JP3 press fitting is the new generation produced with world advanced technologies. It is the mainstream fitting, prevailing in European and
American markets and indicating the development trend of aluminum-plastic
pipe fittings.
The JP3 fitting is made of brass and uses EPDM rubber as the seal. The
EPDM rubber is good at air-tightness and rebound elasticity, and prevents
the mediums like water and gas to impose corrosion on the fitting. Concerning
the structure of the fitting, its element is equipped with two layers of O-type
seals, which can compress the seal slot and inner wall to form two guards
against leakage. Once there is any room between element and inner wall
of the pipe due to thermal expansion and contraction, the seals can rebound automatically to squeeze the air out and ensure high tightness. Besides, the
surface of the element of the JP3 fitting is designed with three rings of tooth
slots, which closely clutch on the PE teeth on the inner wall. In the condition
of thermal expansion and contraction, the PE teeth will tightly clutch on the
slots and secure the fitting's air-tightness. Further, the element of JP3 fitting
is longer than ordinary element (1/3 longer) and the clutched area between
inner wall and the element is increased, and so is the air tightness. Generally,
F5 fittings perform well at air tightness, and are applicable to surface-mounting
and bedding.
The specifications of aluminum-plastic composite pipes that are connected
with the JP3 fittings are 1014, 1216, 1418, 1620, 2025, 2632 and 3240. And
the specifications of threads are G1/2", G3/4", G1", G1-1/4", and G1 1/2".
Three contacts (tees) includes equal tees, reducing tees, male tees and female
tees.
Equal tee: three ends of the tee are connected with pipes of the same size.
A JP3-T1620x 1620x 1620 tee should be connected with 1620 aluminum-plastic composite pipes on all the three ends.
Reducing tee: all the three ends of the tee are connected with aluminum-plastic composite pipes. However, at least one of the ends is reducing. A JP3- T2025x 1620x 1620 tee should be connected with a 2025 pipe and two 1620 pipes respectively
on the left, middle, and right ends.
Male tee: both right and left ends of the tee are connected with aluminum-plastic composite pipes, and the middle end is connected with a female thread. A JP3-T1620x 1/2x 1620 tee should be connected with a 1620 pipe, a 1/2" female thread,
and 1620 pipe respectively on the left, middle, and right ends.
Female tee: both right and left ends of the tee are connected with aluminum-plastic composite pipes, and the middle end is connected with a male thread. A JP3-T1620x 1/2Fx 1620 tee should be connected with a 1620 pipe, a 1/2" male thread,
and 1620 pipe respectively on the left, middle, and right ends.
If this offer has interested you, please, fill the form of inquiry and you receive the answer in ASAP. |
|
|
|
